Code 93 is used primarily by Canada Post to encode supplementary delivery information. It is an alphanumeric, variable length symbology. Most modern scanners contain more powerful controllers and "intelligent" decoding algorithms to read barcodes printed without blank areas.Code 93 is a barcode symbology designed in 1982 by Intermec to provide a higher density and data security enhancement to Code 39. For most two-dimensional matrix symbologies, the requirements for the presence of free zones are less stringent or absent. It`s much better if these areas will be the same color as barcode background. They are required for the scanner to identify the barcode boarders. Spacing is the light areas at the start and the end of the barcode. ![]() This is a very important attribute, especially for linear barcodes. For this reason, for such symbologies, the height of the barcode is made higher than recommended.įor 2D barcodes, the character height is determined by the selected print resolution, the amount of data to be encoded, and other barcode parameters. For example, symbols such as UPC and EAN are commonly used in trade and are often read by multi-beam scanners. Barcode height is also important for applications using multi-beam scanners. Usually, for the majority of linear symbols, the ratio of proportions is considered the best, at which the height of the barcode is 15.20% of its width. At the same time, too high a barcode height leads to an increase in the cost of labels (since the label is taller). A barcode that is too low is difficult for the scanner to read (it is difficult to aim the scanner so that its scan line intersects all the barcode lines). Therefore, for scanning from a long distance (for example, more than half a meter), the barcode must be of very low density, and accordingly the width of the barcode will be large.įor linear barcodes, the vertical direction contains no information and the height of the code is determined only by the ease of scanning. The higher the print density of the barcode, the closer it should be to the scanner when reading. With the same image density, the width of the barcode for different symbols may differ 2-3 times. The density is limited by the resolution of the printer and scanner, but the barcode width depends on the information density of selected symbolic. The barcode width depends on the graphic and information density. For example, a PDF417 10 mils barcode may be considered a high-density barcode however, a 10 mils line code can be recognized as a medium density barcode. The above classification is approximate and depends on the type of barcode. The classification of graphic linear barcodes is shown in the table below: For example, for linear barcodes, the thinner the stroke, the higher the density (and therefore the less space the barcode takes). The graphics density of the barcode is connected with the barcode size. The less the number of bars and spaces required to encode one symbol the higher the information density of the barcode. The information density of a barcode depends on the character encoding. The smaller the value of X, the more characters can be encoded in an inch and, thus, the density rises. The information density is the number of characters that can be encoded per inch given a certain X value. A mil is used to specify the barcode density. There are two elements of density - the graphics density and information density of a barcode. For example, if the narrowest bar is 10 mils it is said that the barcode is printed with 10 mil resolution or that the density of the barcode is 10 mil. This parameter is connected with the printing resolution of a barcode and the barcode density. Module parameter ("Module", sometimes referred to as the "X dimension") indicates the narrowest bar of a barcode. Each type of barcode is defined using the following size parameters. Barcode sizes are very important if they are to read successfully by scanners. Secondly, the density of barcode code simpler connects with the resolution of print devices ability, which is usually expressed dots-per-inch (dpi). Firstly, it`s comfortable, because values are expressed in whole numbers. ![]() The mil inch system is usually used to express the density of barcode code.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |